|
VCL Range
39 models from 70 to 1300 kW
Principle of
operation
The vapour to be condensed is circulated inside the tubes of
the condensing coil, which is continuously wetted on the outside by a
recirculating water system. Air is simultaneously blown upward over the
coil, causing a small portion of the recirculated water to evaporate.
This evaporation rejects the heat from the coil, condensing the vapour
into liquid
Characteristics
- low height
- counterflow design
- forced draught configuration
- horizontal air entry
at one end
- vertical air discharge
- galvanised steel
centrifugal fans with BALTIBOND Corrosion Protection System
- low pressure water
distribution system
- prime surface hot
dip galvanized coil
- V-belt drive
Main features
- low height
- large capacity in
minimum plan area
- side by side arrangement
with up to 4 fans possible
- factory built sections
for minimum site assembly
- suitable for indoor
and outdoor applications
|
 |
|
Material
options
Baltiplus corrosion protection
Baltiplus
Corrosion Protection comprises all steel components fabricated from Z
600 galvanised steel with 600 g of zinc per mē coating. Cut edges are
protected with a zinc rich paint. All fasteners have a 3-stage protective
coating consisting of a zinc phosphate treatment, a zinc rich inorganic
resin coating and an aluminium rich organic top coat. The exterior surfaces
of the equipment are finished with a coat of polymeric zinc aluminium
paint.
Baltibond
Corrosion Protection System
The BALTIBOND Corrosion
Protection System is applied to individual galvanized steel components
prior to assembly. These components are manufactured from Z 600 mill galvanized
steel sheets with 600 g of zinc/mē. After manufacturing the components
undergo an industrial cleaning and drying pretreatment process. Immediately
after the pretreatment the components are electrostatically coated with
a dry, polymeric hybrid thermosetting powder. The coated components are
then put through a thermally activated curing process during which the
powder is fuse bonded to the substrate. Stringent quality control procedures
and regular testing during the coating process assure consistent high
quality of the protection system. The fasteners used for assembly have
a 3-stage protective coating comprising a zinc phosphate treatment, a
zinc rich inorganic resin coating and an aluminum rich organic top coat
|
